To reset the controller network settings to the default:

1. Disconnect power to the controller.
2. While pressing and holding the ID button on the back of the controller, power on the controller.
3. Hold the ID button until ID button turns solid orange and the Link and Power LEDs are solid blue, and then immediately release the button.

Note: During the reset process, the ID button provides the same feedback as

the Caution LED on the front of the controller.

 

To restore the controller to the factory default image:

1. Insert one end of a paper clip into the small hole on the back of the controller labeled RESET.
2. Press and hold the RESET button. The controller resets and the ID button changes to solid red.
3. Hold the button until the ID flashes double orange. This should take five to seven seconds. The ID button flashes orange while the factory restore is running. When complete, the ID button turns off and the device power cycles one more time to complete the factory restore process.